IV-53
ENDING OPERATION
WARNING
O Be sure to stop the saw blade before
cleaning the machine. It is very
dangerous if any part of your body is
caught in the running saw blade.
O When carrying or disposing of flammable
chips (like those of titanium or
magnesium), take due care so that the
chips do not catch fire. Prohibit any use
of fire in the chip storage place.
NOTICE
O If chips are left accumulated in the machine, they may accelerate the
deterioration of the cutting fluid or cause the machine to malfunction.
O To prevent freezing in a cold region, drain the cutting fluid from the hoses after
cleaning the machine.
End the operation of the machine as described below.
1 Turn the lever of the three-way cock in the cutting fluid system to
the left side.
2 Hold the cleaning nozzle, and press and illuminate the CUTTING
FLUID button.
3 Apply the cutting fluid to the chip-deposited areas to clean them.
NOTICE
O Take care so that the cutting fluid does not splash over the control panel.
4 After cleaning the machine, press and extinguish the CUTTING
FLUID button.
5 Remove the chips from the chip box.
6 Press and hold the BLADE DOWN button to move the sawhead
down to the lower limit.
7 Press the HYDRAULIC OFF button to stop the hydraulic pump
motor.
8 Turn the machine circuit breaker switch to OFF.
9 Turn off the shop circuit breaker switch.
To Next Page
Loading...
