II-4
CARRYING
WARNING
O Carrying the machine is not only likely to
damage the machine, but also is very
dangerous. Have a qualified contractor
perform the carrying work.
O Be absolutely sure that the crane, wire
ropes, or forklift used to carry the machine
are strong enough to handle the
machine’s mass.
The mass of the machine is as follows:
HFA-250 and HFA-250W: Approx. 1500 kg {3310 lb}
HFA-400 and HFA-400W: Approx. 2200 kg {4850 lb}
Carry the machine to its location by using a crane or forklift. If a crane
is used, apply the wire rope sling to the front and rear of the machine,
and slowly lift the machine. Do not apply impact to the machine when
lifting or lowering it.
If a forklift is used, insert the forks under the front of the machine, and lift
the machine. Carry the machine to its location while balancing it and
applying no impact to it.
To Next Page
Loading...
