IV-46
INSERTING INTERRUPT STATION IN CURRENT STATION
Example:
field:
field:
field:
field:
field:
field:
field:
field:
field:
Second piece being cut
1
Insert the following cutting data as interrupt station after the second
piece is cut at the station 1 under the above conditions:
Cutoff length (L field): 10 mm
Quantity to be cut (P field): 2 pieces
When the interrupt station is set as described on the next page, the
numbers of the stations become as shown below after the second piece
is cut at the station 1.
The interrupt station is stored as the new station 1, and the former
station 1 and subsequent stations are incremented by one each in
number.
field:
field:
field:
field:
field:
field:
field:
field:
field:
field:
field:
field:
Two pieces already
cut
2
After executing the interrupt station, the machine continues to cut the
third piece at the interrupted station 2 (former station 1).
NOTE
O Depending on the timing of pressing the ENT key to set the interrupt station
as the last step of the entry procedure, the interrupt station may be executed
after another piece is cut at the current station.
To Next Page
Loading...
