IV-39
9 When the front vise
clamps the work, the
HEAD-END
POSITIONING button
extinguishes.
Going from head-end positioning operation
to automatic operation
CAUTION
O If the BLADE DRIVE button is pressed
during the head-end positioning
operation, the saw blade starts running.
If you want to go directly to the automatic operation of the machine after
completing the head-end positioning operation, press the BLADE
DRIVE button while the HEAD-END POSITIONING button is flashing.
After the head-end positioning operation, the machine starts the
automatic operation at the station where the head-end positioning
operation has been performed (or at the station for which the Current
station light illuminates).
To Next Page
Loading...
