iv
All station delete confirmation display .............................. III-23
Runout setup display........................................................ III-23
Station delete confirmation display................................... III-24
Setup display.................................................................... III-24
Result display ................................................................... III-25
Daily report display........................................................... III-26
ALARM HISTORY display................................................ III-27
PASSWORD display......................................................... III-27
Part IV Operation ...........................................................................IV-1
Inspection before start of day’s work........................................ IV-3
Turning on machine.................................................................. IV-3
Selecting saw blade.................................................................. IV-3
Unfolding and folding saw blade............................................... IV-4
Unfolding saw blade.............................................................. IV-4
Folding saw blade ................................................................. IV-6
Installing saw blade .................................................................. IV-8
Adjusting position of wire brush............................................... IV-11
Adjusting position of movable saw blade guide....................... IV-12
Loading and positioning work.................................................. IV-13
Loading work........................................................................ IV-13
Positioning work................................................................... IV-15
Positioning remnant for cutting further ............................. IV-17
Semiautomatic positioning function ..................................... IV-18
Setting cutoff length.......................................................... IV-18
Semiautomatic positioning................................................ IV-19
Adjusting cutting fluid flow rate................................................ IV-21
Running in new saw blade....................................................... IV-22
Stack cutting ............................................................................ IV-23
Stacking workpieces ............................................................ IV-23
Using multi-vises (optional).................................................. IV-24
Runout detector (optional)....................................................... IV-27
Setting runout tolerances ..................................................... IV-27
Handling cutting data............................................................... IV-29
Entering and storing cutting data ......................................... IV-29
Checking cutting data (calling station) ................................. IV-33
Changing cutting data .......................................................... IV-33
Canceling cutting data.......................................................... IV-33
Conditions for execution of cutting data............................... IV-34
To Next Page
Loading...
