6 Series 90B ANNUNCIATOR INSTALLATION AND CONFIGURATION MANUAL
Serial Printer used for Time
Stamped Alarms
(Used with SER option [time
stamped alarms] and SD option
[serial data output]. Modbus, DNP
and Ethernet are not available
when selecting this.)
Ground Fault Detector (internally
mounted)
For 24, 48, 125VDC Field Contact
Voltage (options X, D, XC, DC,
TC)
Additional Two CSM Common
Relays
(Base system includes 2 CSM
Common Relays configurable for
Critical or Non-Critical Horn,
Ringback Horn. The additional 2
CSM Common Relays can be
configured for additional horns or
Critical/Non-Critical Reflash or
Fault, Power Fail, System
Watchdog, or Ground Fault
Detect)
External Inhibit Switch Input
(Software configurable for inhibit
of LED Lamps, Horn, Repeat
Relay Outputs or CSM Common
Relay Outputs)
Automatic Horn Silence
(Can be used to silence any horn
with software configurable delay
up to 60 seconds, in 0.25 second
increments. Independent setting
for internal or external horns)
Flash Synchronization.
Synchronizes the flash rate to
remote displays. Needs to be
specified for each Annunciator
that will be synchronized together.
(Requires wiring between
Annunciator Systems.)
CE Certification
CE Certification available for all
configurations except for FCV
options D, DC, D/ISO, Y/ISO.
In these cases, a NEMA
Enclosure (option N4, N4PB) or
Front Cover (option NCB, NCT) is
required. 120/230VAC & 125VDC
Input Power provided via External
Supplies unless the NEMA
Enclosure or Front Cover is used.
Moisture/ Fungus Proof Coating
To Next Page
Loading...