Series 90B ANNUNCIATOR INSTALLATION AND CONFIGURATION MANUAL
Configuration Wizard
The configuration of an SERIES 90B is defined in a number of sections, which
are displayed on separate pages. The pages may be selected by clicking on the
labeled tabs at the top of each page. When a system is configured for the first
time the ‘Next >>’ button may be used to move through all the sections. This will
ensure that no sections are missed. The ‘<< Back’ button may be used to go to
the previous page if required.
A graphical representation of the annunciator is used to simplify the
configuration. This mimic diagram may be given the same window colors as the
actual unit to make correct input selection easy. Individual or groups of inputs or
modules can be selected by clicking on them. (To select a group of inputs, select
an input with the mouse and hold & drag across other cells. You can also use the
Ctrl key to pick a group of inputs.)
The Configuration Wizard Screens and their functions are detailed below:
System: Used to configure System Size (High x Wide), Window size
per cell and other system-wide features. Once configured and downloaded it will
be locked to prevent any further changes.
Input Configuration: Used to select individual settings per input, such as
input delays, repeat relay operation, critical/non-critical alarms, alarm sequence
groups. These settings can be edited or changed at any time.
Lamp Configuration: Used to configure flash rates for slow, fast and
intermittent speeds as determined by the operating sequence.
Sequence: Selection of the operating sequence for each alarm group.
CSM: Set-up of auxiliary relays and other system-wide functions.
Switch Input: Set up for optional external switch inputs and Test Pushbutton
operation.
ASCII: ASCII set-up configuration. (Only shown when option is enabled.)
Modbus: Modbus set-up configuration. (Only shown when option is
enabled.)
DNP: DNP set-up configuration. (Only shown when option is enabled.)
To Next Page
Loading...
Need help?
General