64 Series 90B ANNUNCIATOR INSTALLATION AND CONFIGURATION MANUAL
Serial ID Mismatch
A serial ID mismatch occurs when you try to upload a configuration that has
already been uploaded to another annunciator. When you upload a
configuration, a note is kept of which annunciator it "belongs to". Every time you
connect to an annunciator the stored serial ID is checked to make sure that it
matches the annunciator you are connected to.
In the case of a serial ID mismatch if you hit continue you will be able to read the
configuration from the annunciator but you will not be able to write the active one
to the annunciator.
To rectify this situation you should click "No" and then open the correct
configuration file, or create a new configuration.
To Next Page
Loading...
Need help?
General