The VIO 4K allows you to choose the output/processing sampling rate used to process the audio (both for
inputs and outputs).
The selected output/processing sampling rate will then be used throughout the whole audio processing, from
input extract to output embed (SEE also: VIO 4K Audio Block Diagram).
To select the output/processing sampling rate:
Front Panel
1. Enter the AUDIO menu on the Front Panel interface.
2. Select Output Settings to set up the audio output.
3. Select Sampling Frequency to select the output/processing sampling frequency.
Possible sampling frequencies include:
4. Press the ENTER key to save and apply the new settings or use the EXIT-MENU button to go back to
the audio output setup menu without saving
Web RCS
1. Go to the Setup menu on the Web RCS interface.
2. Click on the AUDIO tab to access the audio management page.
3. In the left side toolbar, select General to access the audio inputs and outputs setup page.
NOTE: You can also access the audio outputs setup page via the A/V Mapping tab.
4. Under Main Audio (bottom left side window), click on the current sampling frequency to access the
Sample Rate window.
5. In the Sample Rate window, click on the current sampling frequency and select the
output/processing sampling frequency.
Possible sampling frequencies include:
To Next Page
Loading...
Need help?
General
