Related topics:
• Connecting to the Web RCS (LAN)
• Connecting to the Web RCS (USB)
5.5 Enabling the USB device connection
The USB device connection is used by the Web RCS interface to connect to the VIO 4K unit from a PC or tablet
via USB (SEE: Connecting to the Web RCS (USB) for more information).
By default, the USB device connection is disabled on the VIO 4K. You can enable it to control your VIO 4K
unit from a PC or tablet via USB.
To enable the mass storage USB device connection:
Information:
It is strongly recommended to read the section Connecting to the Web RCS (USB) before you start.
Front Panel
1. Enter the CONTROL menu on the Front Panel interface.
2. Select USB Device.
3. Uncheck the Disable Interface check-box to enable the USB device interface connection.
4. Select Connection Mode >MASS STORAGE to connect to the unit as a mass storage device.