5. Under SIGNAL > Format Mode, select GENLOCK to use the Genlock input as a reference to set up the
format.
6. If required, adjust the vertical and horizontal offsets to apply to the output signal:
• Offset H: Offset in pixels (ratio of 1 line) to apply to the output signal.
• Offset V: Offset in lines (ratio of 1 frame) to apply to the output signal.
7. Select APPLY to save and apply the new settings.
TIP: Select Genlock Ref In the left side toolbar and click on Overload Detected Format to specify the format
to use on the Genlock reference input (SEE: Using the Genlock reference).
Related topics:
• Using the Genlock reference
The Area of Interest (AOI) defines the active area of your display in the output format.
The AOI can be thought of as your screen: anything positioned outside the AOI will be ignored in the
processing, and only the AOI content will be displayed to the spectator.
To Next Page
Loading...
Need help?
General
