Web RCS
1. Go to the Edit menu on the Web RCS interface.
2. Select the SCREEN tab to access the screen edit page.
3. On the screen control toolbar (located at the bottom of the screen), select Transition > FADE
THROUGH FRAME.
4. Select PF1 or PF2 to transition through frame using preset frame 1 or 2, respectively.
5. If required, click and drag the Duration control bar to adjust the transition effect duration.
SEE also: Screen management
The Quick Frame function allows you to quickly display a frame in the screen foreground, for example to
cover underneath layers in case of emergency.
You can manage your Quick Frame function by setting up the quick frame (i.e. the frame to display whenever
the Quick Frame function is active), and then enable or disable the Quick Frame function whenever required.
To set up the quick frame function:
Front Panel
1. Enter the FRAME menu on the Front Panel interface.
2. Select QUICK FRAME to access the quick frame function management menu.
3. Select Display Mode to select the aspect ratio used to display the quick frame.
Available display modes for frames include: