Web RCS
1. Go to the Setup menu on the Web RCS interface.
2. Click on the AUDIO tab to access the audio management page.
3. In the left side toolbar, select General to access the audio inputs and outputs setup page.
NOTE: You can also access the audio outputs setup page via the A/V Mapping tab.
4. Under Audio Inputs (right side window), click on an input Ch 1-2/Ch linked button to link/unlink
channel pairs:
• Click the Ch 1-2 button to link channel pairs and use the first channel pair settings for all pairs;
• Click the Ch linked button to unlink channel pairs and set up channel pairs individually.
5. TIP: Use the All shortcut button to apply this setting to all inputs and channel pairs at once.
To mute a channel pair:
Front Panel
1. Enter the AUDIO menu on the Front Panel interface.
2. Select Input Settings and select an input to set up the audio input.
3. Select a Settings Mode to set up the audio:
• Select BASIC to link channel pairs and use the first channel pair settings for all pairs;
• Select ADVANCED to unlink channel pairs and set up channel pairs individually.
NOTE: On the Line In input, there is only one single channel pair and the Settings Mode option is not available.
4. Select a channel pair if required to set up the channel pair.
NOTE:
• In BASIC settings mode, only the first channel pair settings are available and there is no need to select a channel pair.
• In ADVANCED settings mode, you can select a channel pair to access the channel pair settings.
• On the Line In input, there is only one single channel pair and there is no need to select a channel pair either to access
the channel pair settings.
5. Check the Mute check-box to mute the audio pair.
Remember: If channel pairs are linked, the first channel pair setting will be used for all pairs.
To Next Page
Loading...
Need help?
General
