Remember: Use the Reset All shortcut button to reset all inputs and channel pairs at once.
TIP: Click on the Headphone button if required (located under the input) to prelisten to the selected audio pair on
the headphone output.
To enable the equalizer:
Front Panel
1. Enter the AUDIO menu on the Front Panel interface.
2. Select Input Settings and select an input to set up the audio input.
3. Select a Settings Mode to set up the audio:
• Select BASIC to link channel pairs and use the first channel pair settings for all pairs.
• Select ADVANCED to unlink channel pairs and set up channel pairs individually.
NOTE: On the Line In input, there is only one single channel pair and the Settings Mode option is not available.
4. Select a channel pair if required to set up the channel pair:
NOTE:
• In BASIC settings mode, only the first channel pair settings are available and there is no need to select a channel pair.
• In ADVANCED settings mode, you can select a channel pair to access the channel pair settings.
• On the Line In input, there is only one single channel pair and there is no need to select a channel pair either to access
the channel pair settings.
5. Select Equalizer and check the Enable check-box to enable the equalizer on the audio pair (uncheck
to disable).
6. Select TREBLE, MID or BASS to adjust the treble, mid or bass gain, respectively.
To Next Page
Loading...
Need help?
General
