To update your device:
Caution:
Do not switch off the unit during the update. The VIO 4K unit will reboot itself once the update is complete.
Front Panel
NOTE: Before you start:
• Back up your settings if necessary.
• Download the latest firmware from http://www.analogway.com/
• Copy the downloaded AW Firmware Updater (AWP) file into a USB key (root folder).
• Plug-in the USB key into the unit USB HOST port (located on the front panel).
• Wait until the device is properly recognized and proceed as explained below.
1. Enter the CONTROL menu on the Front Panel interface.
2. Select USB Host.
3. Select Scan For Updater.
4. Select Confirm to start the update.
Web RCS
NOTE: Back up your settings and download the latest firmware from http://www.analogway.com/ before you start.
1. Go to the Setup menu on the Web RCS interface.
2. Click on the SERVICES tab to access services available on the device.
3. In the left side toolbar, select Update to access the device update page.
4. Click on Select a file... to open the Upload Update File window.
5. In the Upload Update File window, click on the "..." button and browse for the downloaded AW
Firmware Updater (AWP) file.
6. Click on the Upload button to load the firmware on the device.
7. Click on Start and confirm to start the update.
To Next Page
Loading...
Need help?
General
