POH Editor in "SDH Setup and Status"
TOH Editor in "SONET Setup and Status"
POH Editor in "SONET Setup and Status"
66..11..22..22 StreamsStreams
Touching the StreamsStreams button in the navigation area will display a screen like
the one shown below.
This screen contains the setup of the Ethernet frame content transmitted by the
Network Master. The exact layout depends on the current selection of layers
(i.e. the various encapsulation and protocol headers composing the Ethernet
frame). Touching the button in the top left-hand part of the screen will display
the dialog box to set options related to the layers.
Only the most important (i.e. most frequently used) configuration parameters
are displayed here for each specified layer. To access all parameters, launch
the frame composition 'Stream Setup' dialog box accessible via the button in
the top left-hand part of the screen.
On the Ethernet application over OTN, following layers may not appear depending on
the Client signal setting.
Custom, ETH (Ethernet), MPLS, MPLS-TP, PBB, VLAN, LLC1, SNAP
Composing the Ethernet frameComposing the Ethernet frame
The following headers/layers are available for the frame configuration:
You can use either a 'quick' mode or a 'detailed' mode to set up the selection
of headers/layers. Touching the button at the top of the setup area will launch
the
detailed mode
dialog box (the Stream Setup dialog box ). Touching the
arrow to the right of the button will open the
quick selection menu
.
To Next Page
Loading...
