Allows you to specify the number of frames to transmit.
Loss thresholdLoss threshold
Allows you to specify a loss threshold that is used when an LMM test is active.
If the loss ratio meets or exceeds that threshold, the user is alerted.
SLM tabSLM tab
The SLMSLM tab contains the Synthetic Loss Message parameters:
RateRate
Use the drop-down menu to select the rate at which SLM frames are
transmitted.
Frames to sendFrames to send
Allows you to specify the number of frames to transmit.
Loss thresholdLoss threshold
Allows you to specify a loss threshold that is used when an SLM test is active. If
the loss ratio meets or exceeds that threshold, the user is alerted.
EXM tabEXM tab
The EXMEXM tab contains the Experimental OAM Message parameter:
DataData
Allows you to specify a string which you can send in a message to other remote
maintenance points.
VSM tabVSM tab
The VSMVSM tab contains the Vendor-Specific OAM Message parameter:
DataData
Allows you to specify a string which you can send in a message to other remote
maintenance points.
To Next Page
Loading...
