Discovering devicesDiscovering devices
Discovery view (802.1ag/Y.1731 protocols)Discovery view (802.1ag/Y.1731 protocols)
Touching the DiscoveryDiscovery button available for the 802.1ag or Y.1731 protocol
will display the screen shown below.
The contents of the Discovery view screen is the same for both protocols. The
screen contains the following parameters:
CCM/LBMCCM/LBM
Select the radio button for the relevant method of discovery.
CCMCCM - Passive method. Discover Remote Maintenance points by looking at
incoming CCM frames. This is the preferred method of discovery and the
default selection.
LBMLBM - Active method. Discover other devices by sending out a multicast
loopback message and discover the devices' MAC addresses.
Discovery intervalDiscovery interval
Use the drop-down menu to specify the time period during which to wait and
discover messages.
Max discovered devicesMax discovered devices
Allows you to specify the maximum number of devices that will be discovered.
To discover devices, touch the DiscoverDiscover button on the left side of the screen.
This will display the DiscoveryDiscovery dialog box.
To Next Page
Loading...
