Adding devicesAdding devices
manuallymanually
Devices will appear in the dialog's list as they are discovered. Select the device
in the list and touch the AddAdd button in the dialog box. The device is added to
the list displayed on the Discovery view screen.
To add devices manually, touch the AddAdd button on the left side of the
Discovery view screen. This will launch the Add RmpAdd Rmp dialog box where you
can enter identification data for a specific remote device.
The Add RmpAdd Rmp dialog box contains the following parameters:
DomainDomain
Allows you to specify the MD to which the MEP belongs. You can set the
domain when 802.1ag is selected.
MEG IDMEG ID
Allows you to specify the MEG to which the MEP belongs.
LevelLevel
Use the drop-down menu to select the MD level at which the MEP exists.
MEP IDMEP ID
To Next Page
Loading...
