Anritsu MT1040A - Page 638

Alarm DetectionAlarm Detection
Error DetectionError Detection
Justification analysisJustification analysis
OH CaptureOH Capture
TransceiverTransceiver
Offset (ppm)
Offset
AMP
−131 ppm to +83 ppm (Depending on mapping configuration)
0.1 ppm step
GMP
−150 ppm to +150 ppm 0.1 ppm step
1212..55..33..33 OTN MeasurementOTN Measurement
OTL
LOF, OOF, LOR, OOR, ILA/OLA
OTU, ODU
LOS, OTU-AIS, LOF, OOF, LOM, OOM, SM-TIM, SM-BIAE, SM-BDI, SM-IAE,
ODU-AIS,ODU-OCI, ODU-LCK, PM-TIM, PM-BDI, FSF, FSD, BSF, BSD, MSIM,
TCMi-TIM, TCMi-BIAE, TCMi-BDI, TCMi-IAE, TCMi-LTC (i=1-6)
Multiplexed ODU
LOFLOM, OOF, OOM, ODU-AIS,ODU-OCI, ODU-LCK, PM-TIM, PM-BDI,
MSIM
Client
Client-AIS, PLM, CSF, LSS
OTL
FAS, MFAS, LLM
OTU, ODU
FAS, MFAS, SM-BIP8, SM-BEI, FEC Corrected, FEC Uncorrectable, PM-BIP8,
PM-BEI, TCMi-BIP8, TCMi-BEI (i=1-6)
Multiplexed ODU
FAS, MFAS, PM-BIP8, PM-BEI
GFP
cHEC corrected, cHEC uncorrectable, tHEC corrected,
tHEC uncorrectable, CSF Signal, CSF Sync, Invalid GFP Frame,
Superblock CRC, eHEC corrected, eHEC uncorrectable, FCS,
CMF Sync, CMF Signal, SSF, PTI Mismatch, UPI Mismatch
Client
Bit Error
Count
AMP
Positive(+1), Positive(+2), Negative (−1), offset(ppm)
GMP
CRC8 Error, CRC5 Error, Inc, Inc>1, Inc>2, Inc Over, Dec, Dec>1, Dec>2,
Dec Over, offset(ppm), Cm(t) Max, Cm(t) Min
OTU/ODU/OPU OH, Multiplexed ODU/OPU OH
TTI bytes, FTFL bytes with Multi-frame Manner
Update timing
Repeat 1sec, Single
Module Present
Transceiver Information
SpecificationsSpecifications
638638