Anritsu MT1040A - Page 639

APS MeasurementAPS Measurement
OTN PerformanceOTN Performance
MeasurementMeasurement
Tributary ScanTributary Scan
Round Trip DelayRound Trip Delay
Port modePort mode
TopologyTopology
FramingFraming
ContentContent
Alarm InsertionAlarm Insertion
Error InsertionError Insertion
Alarm, Wavelength and bit rate, Compliance, Vendor Information, Output
Control
Power monitor
MDIO analysis
For QSFP-DD, OSFP:
NVR1, NVR2, Module FAWS, MW Lane FAWS, CTRL, MDIO Read/Write
I2C analysis
For QSFP+ and QSFP28:
Lower, Lower (Lane), Upper (00), Upper (03), Read/Write
Setting
VOD, Pre, Post, DFE
Result : Average switching time, Maximum switching time, Minimum switching
time
Trigger
Start Trigger, Stop Trigger
Measurement Range
0.001 to 10.000 ms
Error Free Period
1, 10, 100, 200, 300, 400, 500, 600, 700, 800, 900 and 1000 ms
Standard
ITU-T Rec. G.8201, M.2401(M.2110)
Supports up to 10 Gbps.
Detected Alarms
OTU-AIS, LOF, OOF, LOM, OOM, SM-BIAE, SM-BDI, SM-IAE, ODU-AIS, ODU-
OCI, ODU-LCK, PM-BDI, LOFLOM
Result : RTD Time
Measurement Range
0.5 seconds, 1 second, 2 seconds, 5 seconds, 10 seconds
Measurement Timing
Single, Repeat
1212..55..44 Fibre ChannelFibre Channel
Off, FC100, FC200, FC400, FC800, FC1200, FC1600
Point to Point, Fabric, E-Port
SOF:Data:EOF, SOF:Header:Data:CRC:EOF
FOX, ALL5555, PRBS 9, PRBS 11, PRBS 15, PRBS 20, PRBS 23, PRBS 29,
PRBS 31, BHFTEST, BCRPAT, BJTPAT, BSPAT, USER_32, ZERO
Item
Link reset, Link reset response, Not optional, Offline
Item
Bit, Symbol, Block, R_RDY, CRC
Measurement FunctionalityMeasurement Functionality
639639