Anritsu MT1040A - Page 641

OBSAI LinkOBSAI Link
Alarm InsertionAlarm Insertion
Error InsertionError Insertion
Frequency OffsetFrequency Offset
Alarm DetectionAlarm Detection
Error DetectionError Detection
Remote statusRemote status
LinkLink
TransceiverTransceiver
Enabled, Disabled
Role
Master, Slave
Protocol version
1, 2
HDLC rate
no HDLC, 240 kbit/s, 480 kbit/s, 960 kbit/s, 1920 kbit/s, 2400 kbit/s, Highest
possible
Ethernet
On, Off
Pointer: 20 to 63
Force idle
Off, IDLE_REQ, IDLE_ACK
Scrambler seed index
0 to 17
RP3 address
0000 to 1FFF
RP3 type
WCDMA/FDD, GSM/EDGE, 802.16, LTE
Forced scrambler seed, Rx filter
Available
Item
Unframed: Signal loss, LSS
CPRI Link: Signal loss, LOS, LOF, LSS, Remote-LOS, Remote-LOF, RAI, SDI,
Reset
OBSAI Link: Signal loss, LOF, LSS
Item
Unframed: Pattern error
CPRI Link: LCV, SHV, K30.7, Pattern error
OBSAI Link: LCV, K30.7, Pattern error
Insertion timing
Manual, Rate
±100 ppm 1 ppm step
Unframed: Signal loss, LSS
CPRI Link: Signal loss, LOS, LOF, LSS
OBSAI Link: Signal loss, LOF, No message, LSS
Unframed: Pattern error
CPRI Link: LCV, SHV, K30.7, Pattern error
OBSAI Link: LCV, K30.7, Pattern error
CPRI Link: Remote LOS, Remote LOF, RAI, SDI, Reset
CPRI Link:
Rx/Tx: Protocol version, HDLC rate, Pointer
OBSAI Link:
Tx state, Rx state
Module Present
Transceiver Information
Measurement FunctionalityMeasurement Functionality
641641