Anthos A7 Plus - Page 56

A7 Plus – OPERATOR'S MANUAL
56
EN
Scaler operating mode selection.
With the instrument in working position, select the scaler operating mode
by touching the following icon buttons:
Standard operating mode.
ENDO operating mode.
PARO operating mode (ENDO with power
reduced by 40%).
The variation is cyclical upon every touch and the icon corresponding to
the active mode is shown on the TOUCH DISPLAY.
NOTE:
with the foot control lever activated, you cannot edit operating
mode.
NOTE:
the data set are automatically saved.
Scaler working programme selection.
The scaler has 4 different working programmes, identified with P1, P2,
P3 and P4, that can be selected by touching the relevant icon button.
Each working programme saves the following data:
- maximum power,
- fiber optic on/off,
- fiber optic brightness,
- type of delivered spray,
- power variation mode.
NOTE:
the variation is cyclical.
Removable hose.
The scaler features a removable hose to make cleaning operations
easier (see paragraph 5.).
Cleaning and maintenance.
Refer to the specific instructions provided with the instrument.
WARNING:
• Do not soak the handpiece in disinfectant liquids or
detergents.
Sterilization.
• Torque wrench, scaler bits and scaler handpiece: steam autoclave up
to 135°C following the instructions for the use of the device.
WARNING:
Carefully read the operating instructions supplied with
the instrument before attempting to sterilise.
Safety standards.
WARNING:
• To avoid hazards or malfunctions when connecting the
board, do not reverse the positions of the hoses for
scalers of different brands.
• The inserts fitted on the handpiece must be in compliance
with Biocompatibility Standard ISO 10993.