Anyview A6 - Page 194

Patient monitor User’s manual
Chapter 19-21
1. NIBP Displaying
2. Setting NIBP
Enter the main menu, Select
【
Module Setup
】
→
【
NIBP Setup
】
, a SpO
2
setup window appears. In the window you can set SpO
2
measurement.
a. Setting Unit
Select
【
Unit
】
, upturn or downturn to choose the unit you need. You can
choose between【mmHg】and【kPa】.
b. Selecting Time Interval
When
【
Mode
】
is set to
【
Auto
】
, select
【
Measure Mode
】
to choose an
appropriate periodic measurement time.
c. Setting Initial Press
Select【Inflation】, upturn or downturn to choose an appropriate initial cuff
inflation pressure according to patient category and requirement.
d. Setting Hypertension Mode
Select 【 Hypertension Mode 】 , upturn or downturn to choose an
appropriate setup. You can choose
【
ON
】
or
【
OFF
】
.
e. Setting Alarm Source
Select【 ALM Source 】 to choose an appropriate setup. You can choose
from
【
SYS&DIA&MEAN
】
,
【
DIA
】
,
【
SYS
】
,
【
MEAN
】
,【SYS&MEAN】、
【DIA&MEAN】and【SYS&DIA】.
f. Resetting
Select
【
Reset
】
to restore the inflation value of blood pressure pump to the
initial value. When BP pump works abnormally but no prompt is
displayed, you may press Reset to check BP pump and to automatically
restore the abnormal working of BP pump caused accidentally.
3. Starting and Stopping NIBP Measurement
Sys
Unit
Dia
Mean