Patient monitor User’s manual
Chapter 26-5
fresh water or neutral soapy water, and wring out surplus water from the
submerged gauze then wipe airbag and pipe;
d) Wash the cuff sheath in the clean neutral soapy water;
e) After the sheath and airbag intensive drying, enclose airbag with cuff
sheath and put into operation.
Excessive or frequent cleaning may damage airbag, so don’t clean airbag
Do not dry airbag and sheath in high temperature.
If higher sterilization level is required, please choose disposal cuff.
One disposal cuff can only be used for one patient.
Carefully keep water and cleaning solution out of the connecting parts of
5． CO2 Sensor and Reusable Airway Adapter
The outside of the module or sensor may be cleaned and disinfected by
wiping with 70% isopropyl alcohol, a 10% bleach solution, or mild soap.
After cleaning, wipe with a clean, water-dampened cloth to rinse. Dry before
Reusable airway adapters may be cleaned by rinsing in a warm soapy
solution, followed by soaking in a liquid disinfectant such as 70% isopropyl
alcohol, a 10% bleach solution, Cidex® or System 1® (refer to the
disinfectant manufacturer's instructions for use). Adapters should then be
rinsed with sterile water and dried.
Reusable airway adapters may also be pasteurized or autoclaved.
Autoclave at 121
℃
(250
℉
) for 20 minutes, unwrapped.
Before reusing the adapter, ensure the windows are dry and residue-free,
and that the adapter has not been damaged during handling or by the cleaning
The IRMA sensor can be cleaned using a cloth moistened with maximum
70% ethanol or maximum 70% isopropyl alcohol.
Remove the disposable IRMA Airway Adapter prior to cleaning the IRMA
The IRMA oxygen sensor cell and IRMA airway adapters are
To Next Page
Loading...
