AOR AR-DV1 - Page 12

10
8 VFO VFO mode (VFO search, Program search, Memory read, Memory scan)
9 FM xx Receive mode: FM AM SAH SAL USB LSB CW
xx: IF BW (bandwidth)
FM: 200 100 30 15 6 (kHz)
AM: 15 8 5.5 3.8 (kHz)
SAH, SAL: 5.5 3.8 (kHz)
USB,LSB : 2.6 1.8 (kHz)
CW: 500 200 (Hz)
(Note: The IF-BW settings are available only in the analog modes. In the digital mode, the IF-BW is
automatically selected.)
10 Dxxxx Digital decode mode
In digital auto decode mode, xxxx indicates decoded mode.
In digital manual mode, xxxx indicates selected mode.
xxxx Decode mode
ALIN Alinco EJ-47U digital
P-25 APCO P-25 Phase 1
dPMR dPMR
D-CR Digital CR / NXDN
DMR DMR
YAES YAESU digital
DSTR Icom D-STAR
11 DA Digital auto decode mode
12 xxx+ Frequency step “+”: Step adjust activated
13 A, B VFO-A or VFO-B
14 xxxx.xxx xx VFO-A frequency in MHz.
15 xxxx.xxx xx VFO-B frequency in MHz.
16 B “Busy” (Squelch opens)
17 “S-meter” Relative signal strength
18 xxx(x) Squelch settings
NSQ (A) : Noise squelch in auto mode
NSQ: Noise squelch
LSQ (A) : Level squelch in auto mode
LSQ: Level squelch
19 VSQ VSQ (Voice Squelch)
20 CTC In FM mode (IF-BW less than 30 kHz)
CTC (CTCSS: Continuous Tone Code Squelch System)
RTN (Reverse CTCSS)
DCS (Digital Code System)