Arjo Tornado - Page 64

64
Measure Each
year/10,000
cycles
Every other
year/20,000
cycles
Time*
(minutes)
3 Process tank
3.1 Clean as required. • -
3.2 Check and clean the level sensor. • 5
3.3 Check that the valves are working and that the
connections are not leaking. Clean as required.
•10
4 Steam Generators
4.1 Check the connections to the steam generator for
leakage and make sure the surrounding insulation
is intact and no hot surfaces are exposed.
•5
4.2 Check that the steam generator is working properly. • 10
5 Main pump
5.1 &KHFNWKDWWKHPDLQSXPSLV¿UPO\DWWDFKHGDQG
that there are no leaks in the connections.
•5
6 Dosing system
6.1 Check the hoses between the dosing pump and
the detergent holder. Replace if necessary.
• ±
6.2 Check the dosage amount. Adjust if necessary. • ±
6.3 Replace hose in the dosing pump. • 5
6.4 Check that the empty container alarm works.
Clean or replace as necessary.
•5
6.5 Check that the door to the detergent cabinet
closes properly (option IPX4).
•1
6.6 Check the function of the check valve in the
steam generator.
•5
7 Drainage connection
7.1 &KHFNWKDWWKHGUDLQDJHFRQQHFWLRQLV¿UPO\
attached and that it is not leaking.
•5
8 Ventilator
8.1 5HSODFH+(3$¿OWHU •10
8.2 Check the fan for proper operation and check that
the connections are tight.
•5
8.3 Check that the check valves are functioning
properly. Clean as required.
•10
8.4 Check hoses to the fan. • 5
9 Automatic door
9.1 Check the automatic closing function (option). • 5
10 Function check (at each service)
10.1 Run a complete process and be sure there are no deviations according to the
periodic checkpoints.
10.2 Check that the panel’s lights and alarms are functioning.
* The time required is estimated with the top off and may vary depending on the installation settings,
operating conditions and equipment level.