VAR8 and Variants Operation, Commissioning, Fault Finding, and Maintenance Guide
sue: 02 complete, approved
-
Is
Page 114 of 166
24.4 Emergency Sounder Operation
4. It is possible to suppress or enable the fault sounder during announcements from the fire microphone
through the following menu.
Menu: ConfigurationÆSystemÆRouterÆMiscÆSounder
‘Error beep with fire mic=Enabled’ means that the fault sounder is enabled during fire microphone
announcements.
‘Error beep with fire mic=Suppressed’ means that the fault sounder is disabled during fire microphone
announcements.
L
The fault sounder is automatically suppressed when the VAR8 is networked. This setting only
affects the fault sounder when the VAR8 operates in stand-alone mode.
24.5 Host Routing Timeout Configuration
The Host Routing Timeout is the time the Router waits for a message from the host system before clearing
any routes that have been instigated by the host system.
Enabling this timeout provides a clear down mechanism so that if the host system fails it does not lock up the
PA system’s operation from other input sources.
5. Enable (or disable) the route clearing and set the timeout time through the following menu as required.
By default, after 1 min timeout the Router clears any routes that have been instigated by the host
system.
Menu: ConfigurationÆSystemÆRouterÆMiscÆHost Timeout OR Host T/Out
24.6 Temperature
The Router has an over-temperature alarm, and it is possible to configure the internal temperature at which
this alarm is raised, as described in the following step.
6. Enable (or disable) and set the temperature through the following menu as required.
By default, fault reporting is disabled.
Menu: ConfigurationÆSystemÆMiscÆTemp
To Next Page
Loading...
Need help?
General
