VAR8 and Variants Operation, Commissioning, Fault Finding, and Maintenance Guide -
Is
Page 165 of 166
sue: 02 complete, approved
Service and Warranty
Name and Address of Authorised Distributor:
This product carries a full warranty. For full details of warranty and
service agreements, please contact the Authorised Distributor who
supplied the product to you.
Exclusions
The warranty does NOT cover:
5. Customer misuse, including incorrect installation.
6. Damage other than manufacturing defects.
7. Transit / Courier damage.
8. Incorrect voltage or power supply used.
9. Incorrect input signal.
10. Abnormal environmental operating conditions.
11. Damage incurred by accident, fire, lightning or other hazard.
12. Modification to the unit or inexpert / attempted repair.
13. No fault found – where no fault can be found after extensive
testing, indicating user error or failure in ancillary equipment.
14. Electronic assemblies which are improperly packed when
returned for repair or service. All electronics assemblies
must be properly packed in ESD protective packing for
transport to prevent physical and ESD damage. Use of non-
ESD protective packing for return for repair or service will
automatically invalidate the warranty.
Should any of the above apply, Application Solutions Limited reserves the right to raise any relevant charges to the customer.
Application Solutions Limited shall not be liable for any indirect, special or consequential loss or damage (including without limitation any
loss of profits) arising from the use of this product or for any breach of this warranty.
In the interest of continual product development, Application Solutions Limited reserves the right to make changes to product
specification without notice or liability
.
To Next Page
Loading...
Need help?
General
