Getting Started
QL-E100 User Guide 14
5. Press the power button for two seconds and then release it. The power button will light green
and you will hear the printer initializing.
6. When the printer has fully powered on, the touchscreen will be ready for use. Check the ink
level area on the left side of the touchscreen.
The ink level will be displayed using visual CMY bars. The ink level is also displayed as a
percentage under the bars. After installing the new ink cartridge, the ink level will be shown as
full (100%).
Note: If the ink level is not displayed, the ink cartridge might not be installed properly. If this
happens, reinstall the ink cartridge and be sure it fully clips into the cradle.
Installing the Printer Driver
The QL-E100 printer driver software allows your computer to communicate with the printer. Use
the following instructions to download and install the printer driver on your computer.
Important: This procedure requires administrator rights in Windows.
1. Make sure that the printer is powered off. If the printer is on, press the power button for
two seconds and then release it. The power button will light red and the printer will shut down.
Important: Do not connect the printer to your PC with the USB cable at this time. The USB
cable will be connected later in this procedure when prompted.
2. Download the QL-E100 printer driver from the AstroNova Product Identification website.
See AstroNovaProductID.com/QL-E100support. Save the file to your desktop for
convenience.
The file will be named Setup_QL_E100_WindowsDriver_V#.##.exe. The last part of the file
name indicates the version number of the driver.
To Next Page
Loading...
