Safety
QL-E100 User Guide 85
Power Supply and Power Cord
Warnings
• To avoid causing a fire or serious electrical shock, always use the power cord provided with
this printer. To avoid a fire or electrical shock, do not use an extension cord.
• To avoid a fire or serious electrical shock, connect the printer power cord to an independent
power source that is not shared by other equipment or appliances.
• To avoid causing a fire or serious electrical shock, make sure that the power plug is securely
and completely inserted into the power source.
• Do not cut, damage, or otherwise alter the power cord. To avoid the dangers of fire and
electrical shock, never place a heavy object on the power cord, never expose it to heat, and
never pull on the cord to disconnect it. If the power cord is damaged in any way (condensation
on exposed wires, broken wires, etc.) contact the dealer where you purchased the printer or
the nearest service center for a replacement.
• To avoid personal injury from an electrical shock, never handle the power cord or plug when
your hands are wet.
• To avoid a fire or serious electrical shock, never knot the power cord or wrap it around itself.
• Disconnect the printer power cord during severe electrical storms. Lightning could cause a fire
or severe electrical shock or damage to the printer.
• To avoid a fire hazard, occasionally disconnect the power cord from the printer and the power
supply and use a soft dry cloth to clean the cord connectors and the connection points.
Leaving the cord plugged in and not cleaned for a long period, especially in an area subject to
dust, oil, and high humidity, could cause the insulation material to deteriorate.
Cautions
• Be sure to turn off the printer before removing the power plug from the outlet.
• Check the power plug and cord for any problem (abnormal heat, rust, bend, cracks, scratches,
etc.) at least once a month.
• If any problem with the power plug or cord is found, replace it. Using it without replacement
can result in a fire or electrical shock hazard.
• To avoid damaging the power plug, which could cause a short circuit and cause a fire or
electrical shock, never pull on the power cord to unplug the cord from the power supply.
Always grip the plug to remove it from the power supply.
• If the printer will not be used for a long period, for your safety disconnect the power cord from
the power source.
• Always keep the area around the power plug free of obstacles so you can unplug it easily. This
allows you to unplug the power cord quickly in an emergency.
• Never use any power source other than the one rated for the printer. This printer is designed to
be used in the region where purchased. Also, make sure the power source can supply
sufficient power for the printer. This could cause a fire or serious electrical shock, or damage
the printer.
• The printer must be connected to a socket-outlet with grounding connection by the provided
power cord.
To Next Page
Loading...
