Touchscreen Controls and Functions
QL-E100 User Guide 63
Vertical Offset
The Vertical Offset is zero by default, resulting in no vertical adjustment.
You can tap the Vertical Offset field to change the offset. Enter an offset from zero to 200 (in
tenths of a millimeter). Increasing the vertical offset moves the printed image away from the
indicated edge.
1st Page Vertical Offset
The 1st Page Vertical Offset is similar to the Vertical Offset, but it applies only to the first label in
a job. The gap on the leading edge is smaller than gaps between subsequent labels and it requires
a separate adjustment.
The 1st Page Vertical Offset is zero by default, resulting in no vertical adjustment.
You can tap the 1st Page Vertical Offset field to change the offset. Enter an offset from -100 to
100 (in tenths of a millimeter). Positive values move the image up and away from the gap.
Negative values move the image down and toward the gap.
Save Changes
Tap the Save icon to save the changes you made in the Offsets tab.
Restore Defaults
You can tap the Defaults icon to restore the original settings in the Offsets tab.
To Next Page
Loading...
