AstroNova QuickLabel QL-E100 - Page 65

Touchscreen Controls and Functions
QL-E100 User Guide 65
Unidirectional
The printhead carriage moves horizontally across the media during printing. By default, the
printhead will print while moving in both directions.
If you enable the Unidirectional option, the printhead will print only when moving from right to left.
Sensor
Select a sensor type.
• Continuous - Choose this option if you are using media without gap or reflective marks.
• Gap - Choose this option if you are using gap media.
• BlackMark - Choose this option if you are using reflective mark media.
Media Type
Select a media type. The optimal QuickLabel color profile will be applied based on the selected
media type.
Scaling
You can adjust the sizing of the printed image.
• None - Select this option to leave the sizing unchanged.
• Auto Fit to Page - Select this option to resize the printed image to fit the label size.
Paper Width
Select the width of your labels. You can select a preset width from the list or enter a custom width.
Cutting Setting
Set up the cutter options.
• None - Select this option to disable the cutter.
• Every Label - Select this option to cut after each label is printed.
• End of Job - Select this option to cut at the end of the print job.
Auto Rotation
You can use auto rotation to automatically set the label artwork to portrait or landscape based on
the media being used.
• Disabled - Select this option to disable automatic rotation.
• Enabled - Select this option to enable automatic rotation. Label artwork will automatically be
rotated to match the media orientation.