Touchscreen Controls and Functions
QL-E100 User Guide 67
Print Pattern
The Print Pattern icon prints a nozzle alignment pattern. Left and right offsets are used to align
the color bars. These are factory settings that should not be changed unless specifically
instructed.
Alignment Adjustments
Enter any alignment adjustments if required.
• Print Start - Sets the horizontal printing start position from the rightmost (facing the printer)
edge of the media. This is factory set and should not be changed, unless the Horizontal
Offset function in the Offsets tab is not able to adjust the position of the image as desired.
• Feed Length - Sets the amount of media fed after printing is completed.
• Vertical Baseline - Sets the vertical print start position relative to the gap or black mark top of
form. This is a factory setting that should not be changed unless specifically instructed.
Vertical image position can be adjusted using the Vertical Offset controls in the Offsets tab.
• Cut Position - Sets the cutting position relative to the gap or black mark top of form.
Save Changes
Tap the Save icon to save the changes you made in the Alignment tab.
Restore Defaults
You can tap the Defaults icon to restore the original settings in the Alignment tab.
To Next Page
Loading...
