Released Rev. C 2000-1252-01 Page 111
VersaPort 2200 Technical Manual
Chapter 4: Service
CSP4 – Cassette Shuttle Motor Replacement
a
_____13. Connect a PC with null modem cable to the Host port of the VersaPort.
Connect 24vdc power. Use ISIM software to test the operation of the
VersaPort. For information on using the software, see “Appendix A: ISIM” on
page 123.
_____a. From the Main menu select F9 (SMIF OPTION). Use the arrow keys to
select LPO/VersaPort and press Enter.
_____b. From the Main menu select F2 (MANUAL).
WARNING
MECHANICAL HAZARD
A PINCH HAZARD EXISTS AT THE PORT PLATE WHEN THE
MINIENVIRONMENT IS REMOVED. DO NOT PLACE FINGERS OR
HANDS IN THE PATH OF THE PORT PLATE.
_____c. From the Manual menu select F8 (MISC), then select CALIBRATE
HOMING. The VersaPort will perform a homing calibration to verify home
position. Observe the spacing around the port door and port plate. The
gap should be even around the port door. If necessary, perform “CAP4 –
Calibrate Shuttle Homing Offset” on page 87 to adjust the shuttle position.
_____d. Place a Pod with cassette on the port door. Perform an autocycle to verify
operation of the VersaPort.
_____e. From the Auto menu select F9 (AUTOCYCLE). The VersaPort will raise to
the Stage position, move the shuttle forward, retract the shuttle and return
to the Home position.
_____f. The VersaPort will continue to cycle until F9 is pressed to stop the
Autocycle function. Press F9 (STOP CYCLES). The VersaPort will
complete the current cycle and return to the Home position. Remove the
Pod from the port plate.
_____g. Close the ISIM program. Press F10 (MAIN) to select the Main menu.
_____h. From the Main menu select F8 (EXIT). Use the arrow keys to select Yes
and press Enter to close the program.
_____14. Remove 24vdc power and communications cables from the VersaPort.
Post-Service
_____1. Replace the minienvironment inner shield to the port plate with the four
screws, two at each side.
_____2. Replace the two outer shields of the minienvironment. Grasp the inner (lower)
section slightly below the upper section so it does not restrict the top edge of
the minienvironment from sliding into the track on the port plate. Pus the
minienvironment evenly along the edge of the port plate.
To Next Page
Loading...