Page 60 2000-1252-01 Released Rev. C
VersaPort 2200 Technical Manual
Chapter 4: Service
Preventive Service Procedures
a
Preventive Service Procedures
Verify the DAC values of the port plate laser system every three to six months (depending
on cycles) to ensure the system is properly aligned. Perform Verify DAC Values
procedure beginning next page.
At the same time, visually inspect the VersaPort to ensure no components are out of
alignment and there is no sign of undue wear. If adjustments are required, refer to the
applicable Calibration/Alignment Procedure to resolve the problem.
This section lists the VersaPort preventative maintenance tasks.
Description
“PSP1 – Verify Laser Sensor DAC Values” on page 61
To Next Page