Page 8 2000-1252-01 Released Rev. C
VersaPort 2200 Technical Manual
Chapter 1: Safety
EMO & Electrical Power
a
Equipment Lockout/Tagout Procedure
Lockout/tagout procedures must be followed during installation or when service is
performed on the VersaPort to prevent injury or equipment damage. Where no company
procedures exist, follow the guidelines below:
1. Notify all affected employees and users that service is to be performed and that the
equipment needs to be shut down and locked out.
2. The Process Tool must be powered down, or the circuit that provides power to the
VersaPort must be switched off.
3. Lock out the circuit with an assigned lock.
4. Test to make sure the VersaPort cannot be turned on accidentally.
5. Tag the locked circuit with a statement indicating:
• Unauthorized operation of the equipment or removal of tag is prohibited
• Date of service performed
• Names of the persons performing the service
To Next Page
Loading...