Trip Page
Envision EX5000 -60- 600-00151-001 Rev 01
10) Select knob—Use the right knob to move the cursor over the
desired waypoint in the flight plan, which selects the plain-text
METAR to be displayed along the bottom half of the screen.
!
Garmin GNS400/500-series users: When the EX5000 is
interfaced to a Garmin GNS400/500-series GPS via RS-232,
the GPS may send duplicate waypoints while in approach
mode. These duplicate waypoints may affect the distance
and time readings on the Trip page. Use the GPS as the
primary source of navigation information for approach
procedures. Consult your avionics installation facility to
determine if your EX5000 is interfaced to the Garmin GNS-
430 via ARINC 429 or RS-232.
To Next Page
Loading...
