11
What you should know
F-FEM-CON — User’s Guide
1 What you should know
1.1 Safety Instructions
This documentation contains important warnings and safety instructionns to
be observed by the user. Smooth operation only is ensured, if the necessary
prerequisites and safety measures are kept.
1.2 Warranty Seal
For safety reasons the product is provided with a special seal which may only be
broken by AVL personnel. Any unauthorized damage to the seal is considered
an unauthorized change to the product which will cease AVL's warranty obliga-
tion.
1.3 Intended Application
The product is only intended for the area of application described in the docu-
mentation. We do not give any warranty and do not accept any liability for appli-
cations outside the described utilization or in the event of noncompliance with
the necessary conditions and safety instructions. The supported protection of the
product could be affected.
1.4 Product specific information
The F-FEM-CON (Fast-Front End Modul Controller) is part of a family of Front
End Modules that operate together in a network. Data communication takes
place via an IEEE1394-compatible bus. Thus, within a PUMA system real time
data communication is ensured.
FEMs Classic (older generation) and F-FEMs (new generation) can be operated
parallel to each other in the PUMA Open system.
An F-FEM-CON enables the user to acquire speeds, frequencies, time periods
and events and to output demand values (such as voltages, currents, frequen-
cies or digital signals).
A number of F-FEMs and Basis-FEMs can be used with the PUMA Open
system. The total sampling rate for all connected F-FEMs depends on the
applied PUMA Open version.
For details, please refer to Performance Data on page 15.
Information
You will find abbreviations in chapter Glossary and Abbreviations on page 105.
To Next Page
Loading...
Need help?
General
