AVL F-FEM-CON User Manual

23
Installation
F-FEM-CON — User’s Guide
3.2.2 Fixing the Module at the DIN Rail
The F-FEM-CON has been designed for top hat rail mounting (DIN rail; TS35
according to DIN EN 50022). For mounting/dismounting, you need a screw
driver size 6.
1. Use a screw driver as a lever and pull down the module locking (1).
2. Assemble the module on the DIN rail (2) while holding the locking.
3. Remove the screw driver so that the lock (3) snaps into place under the
DIN rail.
Fig. 6
1..... Module locking
2..... DIN rail
3..... Lock
NOTICE
When mounting the device in a cabinet, make sure not to cover the vents to
allow sufficient air to circulate. The minimum distance between cable duct and
upper side or lower side of the module should not be less than 40 mm.
3.
2.
1.
1
2
3

AVL F-FEM-CON Specifications

General

Brand	AVL
Model	F-FEM-CON
Category	Measuring Instruments
Language	English