Barco DP2K-23B - Projector Tilting

3. Physical installation
SCREEN CENTER SCREEN CENTER
OFF-CENTER
A B
Image 3-2
Projector centering
3. Proceed to level the projector by adjusting the feet of the projector as follows:
- Loosen the nuts ( A), u sing a wrench of 24 mm, on the threaded rod.
- Adjust the height of the 4 legs (B) to level the projector, using a 17 mm wrench.
- Secure the leg height by tightening the nuts (A).
Note: There must be at least 5 cm between the bottom side of the projector and the pedestal.
A
B
Image 3-3
Projector leveling
4. La ter, when the projector is up-and-running, adjust precise im age geometry an d p lacement.
Projector tilting
In an ideal installation, the DP2K-23B lens surface is centered with and parallel to the screen. This orientation helps to ensu re
optimized lens performances with minim al offset. If this position is not possible (such as when the projector is significantly higher
than the center of the screen), it is better to rely on o ffset rather than extra tilt.
1. Before adjusting tilt, make sure the projector is as well-centered with the theatre screen as pos sible for your installation area.
2. C heck with theatre personnel for th
e degree of s creen tilt, or m easur e this incline with a pr otractor at the screen.
3. Tilt the projector to closely match this screen tilt angle as follows:
- Loosen the nuts ( A), u sing a wrench of 24 mm, on the threaded rod.
- Adjust the height of the legs until the projected image matches the projection port window and the screen tilt.
- Secure the leg height by tightening the nuts (A).
R59770495 DP2K-23B 30/04/2010
19