Barco DP2K-23B Installation Manual

5. Lenses & lens holder
5.4 Lens installation
How to install a lens
1. R emove the foam rubber in the opening of the lens holder if not rem oved yet.
2. Take the lens assembly out of its packing material and remove the lens caps on both sides.
3. Place the lens holder in the “unlocked” position by m oving the lens lock handle (1) towards the lens power supply socket (2).
1
2
3
Image 5-7
Unlock l ens holder
4. Ensur e that the lens holder stands in the On-Axis position (horizontal and vertical mid pos ition).
Note: The lens holder is placed default in the On-Axis po sition at factory.
5. Gently ins ert the lens in su ch a w ay that the lens connector matches the socket.
Image 5-8
Mount lens
6. Insert the lens until th e connector seats into the socket.
- the pin ( 3) on the lens holder matches with the sleeve in the lens.
- the connector seats into the socket (2)
Warning: Do not release the Lens yet, as the Lens m ay fall out of the Len s Holder.
R59770495 DP2K-23B 30/04/2010
49

Barco DP2K-23B Specifications

General

Contrast ratio (typical)	2000:1
Projector native resolution	2K (2048x1080)
Ethernet LAN	Yes
Ethernet LAN (RJ-45) ports	3
AC input voltage	200 - 240 V
Lamp power	4000 W

Weight and Dimensions

Depth	754 mm
Width	604 mm
Height	1129 mm
Weight	133000 g