3. Physical installation
3.6 Connecting a UPS to the projector electronics
WARNING: Only u se UP S units which are s uitable for the DP2K-23B projector. See ch apter ”General”, “In-
stallation requirements” for more information about the requirements of the UPS.
How to c onnect the UPS
1. Install the UPS according to the instructions of the manufacturer a nd the local regulations.
2. C onnect the powe r output cord from the UPS unit to the UPS inlet socket of the projector (right socket).
Connect directly (A) or drag the c able behind the front cover so that the front cover c an be rem oved without
removin g the UPS
INLET cable (B).
1
2
A
B
Image 3-11
UPS connection
3. S ecur e th e UPS inlet socket with a fixation spring. Handle as follow:
- Squeeze the fixation spring together.
-Slidethefixation spring on the fixation pins while squeezing together and push it against the power plug.
- Release the fixation spring.
4. Install on the power outlet the second fixation spring to prevent losing it (2).
CAUTION: T he electrical co nn ection with the UPS INLET so cket of the projector m ust be done with a c ertified
AC power supply cord (minimum 0,75 mm² or 18 AWG and minimum 300V )
CAUTION: Do not use t he power OUTLET socket of the projector to provide power to other equipment!
26 R59770495 DP2K-23B 30/04/2010
To Next Page
Loading...
