Barco DP2K-23B Installation Manual

2. General
2.3 Initial inspection
General
Before shipment, the projector was inspected and found to be free of mec hanical and electrical defects. As soon as the projector is
unpacked, inspect for any dam age that m ay have occurred in transit. Save all packing material until the inspection is com pleted. If
damage is found, file claim with ca rrier imm ediately. Th e B arc o Sales and Service office should be notified as soon as possible.
The packag ing of the DP2K-23B digital projector is provided with a shock-watch label. If this shock-watch
label was triggered (red colored at arrival) during transpo rt, indicates that the packag e was poss
ibly roughly
handled by t he transport company. In this case, the instructions mentioned o n the label, should be followed,
which are: adding a note on the “bill of lading” and informing the transport company and the Barco sales and
service office as s oon as possible.
Box content
After unpa cking the projector it is recommended to check if all following items where include
d:
• One short power link cable (mono phase) (in c ase no U PS is used) - Installed on projec tor.
• This manual (installation manual).
•CD
• Safety manual
One xenon lamp is mounted inside the lamp house at deliv ery. The projector lenses are not included in the
package of the projector.
Mechanical check
This chec k should confirm that there are no broken knobs or connec tors, that the cabinet and panel su rfaces are free of dents and
scratches, and that the operating p anel is no t s cratched or cracked. T he B arco Sales and Service office should be notified a s soon
as poss ible if this is not the case.
Tamper labels
During installation please inspect the tamper labels, if they are da maged please contact Barco tech support.
The tamper labels are required by DCI to provide easy visual indication if the equipm ent was tampered with. The projectors a re
tested and labeled for shipping to ensure that the system was not compromised before reaching the customers final d estination.
These tam per labels can be found behind the input cover. See "Removal of the input c over", page 91.
R59770495 DP2K-23B 30/04/2010
15

Barco DP2K-23B Specifications

General

Contrast ratio (typical)	2000:1
Projector native resolution	2K (2048x1080)
Ethernet LAN	Yes
Ethernet LAN (RJ-45) ports	3
AC input voltage	200 - 240 V
Lamp power	4000 W

Weight and Dimensions

Depth	754 mm
Width	604 mm
Height	1129 mm
Weight	133000 g