4. Getting Started
Image 4-2
4.5 Power off projector
How to Switch off the projector
1. Use the standby button,orthePow er On button on the remote con trol, to switch off the projector.
The projector will sw itch to READY mode first in order to run t h ro
ugh a cool down phase (see "Power m ode transitions", page
25).
2. If ECO Standby mode is enabled in the service men u (refer to the s ection "GUI - system settings/Standby E CO ", in User Guide)
the projector will autom atically go to ECO standby mode after a time-out (default 15 minutes).
Some actions like apply a grey test pattern are done during the two minutes of the cool down phase in order
to minimize the potential effect of burn-in and increase the projector lifetime.
CAUTION: Never switch off the projector b y m ea n
s of unplugging mains cord or by cut down of mains power.
Barco advises to keep the projector alw ays powered and use the EC O mode for low power con sum ption.
How to unplug the projector
1. Follow the procedure above to Switch Off the projector.
2. Wait at least 2 minutes prior to unplug the projector by removing the p ower cord from the AC outlet.
CAUTION: It is very important to wait few minutes before unplug the power cord. If the cool down phase is
not adhered, projector lifetime could be degraded.
4.6 Operation in 24/7 Mode
General
When the projector is de stined to be operated continuously 24 hours a day / 7 days a week, some rules must be followed to minimize
the potential effect of burn-in and increase the projector lifetime.
R5906852 F80 SERIES 21/09/2017
27
To Next Page
Loading...
