128 of 285
Scan Table Select
This section selects the Scan table to be used when the transceiver is put in scan,
or if enabled, when scan resume occurs.
There are 8 scan tables.
Note:- When scrolling through the scan tables, before selection, only those with
channels entered will be displayed.
Note:- Channels can be added, removed and edited and scan tables named in the
“Scan table” section.
Use the Scroll keys to select the scan table required (example
scan table 1):-
When the scan table required is displayed press the key
If none of the Scan tables have any channel entries the following
is displayed:-
Note:- Direct entry into this section is available by pressing the key for
more than two seconds.
To Next Page
Loading...
