68 of 285
Special Characters in a Pagecall
As from V2.00 of transceiver firmware “Pagecall” selective call messages have the
ability to send special characters out as part of the message. These special
characters are ‘*’, ‘#’ and ‘.’. To get the new characters to display properly the
transceiver front panel unit needs to be fitted with V14 or later firmware.
press the key
select “Pagecall” with the scroll keys
then press the key
enter the identification of the station you want to send the
Pagecall to (see “Entering station IDs and using the address
and telephone books”)
then press the key
To Next Page
Loading...
