48 of 285
Hang-up Call
When a call to a telephone interconnect base station has been completed the caller
should "hang up" by sending a “hang up” code:-
press the key
select “Hang-up” with the scroll keys
then press the key
select the ID of the telephone interconnect that you are connected
through
then press the key
When the hang-up Selcall has completed transmitting, listen for hang-up revertive
signal, confirming the “hang up” was successful, if not heard repeat the above
procedure.
Note:- If the hang up call is un-successful for any reason the telephone
interconnect will time out and hang-up itself.
To Next Page
Loading...
