265 of 285
Mounting the Whip Sections
To mount the whip section it is recommended that only one section of the whip is
screwed onto the antenna at a time. The whip section should be hand tightened fully
then a suitable tool (i.e. a spanner) can be used to tighten the section a further 10 to
20 degrees clockwise while holding the antenna body with a free hand.
To mount 2 whip sections together the unattached whip section should be hand
tightened fully then a suitable tool (i.e. a spanner) can be used to tighten the section
a further 10 to 20 degrees clockwise while holding the already screwed on whip
section with a free hand.
To Next Page
Loading...
