192 of 285
Receiving an ALE Telephone Call
If the RS-232 output is disabled (see I/O section of the Protected Menu) ALE
telephone call requests are displayed on the transceiver front panel as follows:-
When an ALE link to your station commences the following is displayed on your
transceiver:-
A station in the ALE net is attempting to establish a link to your
station:-
Your station is now linked and has received an ALE phone
number, an audible alarm sounds:-
If after 60 seconds no key has been pressed the alarm will stop
and regular ‘blips’ will be heard indicating a call was received in
your absence. Pressing any key will display the received
message:-
Pressing the key shows the address that the station called
i.e. one of your addresses:-
Pressing the again shows the address of the station that
called you:-
To Next Page
Loading...
